There are many approaches to the problem of activating a light when it
becomes dark, and a recent Design Idea covers this topic (Reference 1).
Some approaches require a dc power supply and an electromechanical
relay, but a better approach involves feeding the device directly from
the ac line, minimizing the number of components
(Figure 1).
Figure 1. The photoresistor activates the TRIAC and the load when darkness falls.
The heart of the device is a light-sensitive cadmium-sulphide resistor,
PR, with a resistance of approximately 200 kΩ in the dark and decreasing
to a few kilohms in the light. PR and capacitor C1 form an ac-voltage
divider. In daylight, the voltage across PR is too low to generate the
required gate-trigger current to turn on bidirectional ac switch Q1,
thus keeping the load – usually a lamp – off. When it becomes dark, PR’s
resistance rises, resulting in an increase in the TRIAC’s gate current
that triggers the TRIAC and lights the lamp.
The circuit uses inexpensive, off-the-shelf components, including the VT90N1 photoresistor; a 0.1-μF, 275V capacitor; and an L2004F61 TRIAC with a load current of 4A rms, a peak blocking voltage of 200V, and a gate-trigger current of 5 mA. The exact specifications of these components are not critical; you could use others instead.
Editor’s note:
Attributes worth mentioning include the fact that the capacitor introduces a phase shift, which places the peak of the gate voltage close to the zero crossing of the load’s sine wave for optimum turn-on timing. Another benefit is thermal hysteresis, which occurs due to the reduction of the required triggering voltage and current as the TRIAC warms up after the initial turn-on. Link
The circuit uses inexpensive, off-the-shelf components, including the VT90N1 photoresistor; a 0.1-μF, 275V capacitor; and an L2004F61 TRIAC with a load current of 4A rms, a peak blocking voltage of 200V, and a gate-trigger current of 5 mA. The exact specifications of these components are not critical; you could use others instead.
Editor’s note:
Attributes worth mentioning include the fact that the capacitor introduces a phase shift, which places the peak of the gate voltage close to the zero crossing of the load’s sine wave for optimum turn-on timing. Another benefit is thermal hysteresis, which occurs due to the reduction of the required triggering voltage and current as the TRIAC warms up after the initial turn-on. Link
