The circuit below will trickle charge a four cell pack of AA or AAA NiMH batteries. The circuit draws current from the +5v available a USB connection and pumps about 70ma of current into the battery. This should be enough current to fully charge a pack of 2500ma-hour cells in about 36 hours. The circuit uses a single 74HC14 hex Schmitt trigger inverter in conjunction with a voltage doubler charge pump circuit.
Find us on Facebook
Popular Posts
-
This is the 25W Class-A power audio amplifier circuit. The output devices are MJL4281A (NPN) and MJL4302A (PNP), and have high bandwidt...
-
This is the schematic diagram of 3 channels audio splitter amplifier circuit which built using op-amp IC TL084. The 3 channels amplifier ...
-
The receiver circuit in Figure 1 sounds an audio alarm when the transmitter (Figure 2) moves beyond a designated perimeter. The transm...
-
The pulser is intended to switch the mains voltage on and off at intervals between just under a second and up to 10 minutes. This is use...
Powered by Blogger.

