LA4440 is a dual channel audio amplifier
IC. It can be used in two modes; one is Stereo amplifier and another
Bridge amplifier mode. The LA4440 is a monolithic linear IC from Sanyo.
Here I give the both circuit mode of amplifier using IC LA4440.
When the IC LA4440 is Stereo mode in the circuit, its output power is 6w+6w. In stereo mode use two pieces speaker of 2Ωto8Ω.
When the IC LA4440 is Stereo mode in the circuit, its output power is 6w+6w. In stereo mode use two pieces speaker of 2Ωto8Ω.
C10 is filter capacitor used to reduce the ripple of supply voltage. Don’t decrease the value of capacitor C6&C7 less than 100uF, 10v, it may causes of the output at low frequencies goes lower. The pin-6 of LA4440 amplifier circuit is audio input pin; it used in stereo amplifier mode but in bridge mode it is grounded. C8&C9 are polyester film capacitor used to preventing oscillation, and R1&R2 used for the same reason as filter resistor. Though the maximum supply voltage for both circuit of amplifier is 18V but we recommend to use a 12V,3A power supply. Use a good quality heat sink with LA4440.
I think here you see little comparison between stereo and bridge
amplifier of LA4440. If you want to make this amplifier project, then I
recommend you the bridge one. I think it is ideal for a beginner. And I
love its wattage rather than Stereo mode. There is also a possibilities
as I say, make two copies of circuit of bridge amplifier for stereo, it
will give you 19w+19w of audio power output.
