Simple Battery Low Voltage Beeper circuit provides an audible and visual low voltage warning for 12V
battery powered devices. When the battery voltage is above the set point
(typically 11V), the circuit is idle. If the battery voltage should
fall below the set point, the LED will light and the speaker will emit a
periodic beeping sound to warn of the impending loss of power. The
circuit was designed for monitoring solar systems, but it could also be
useful for automotive and other 12V applications.
Specifications:
Specifications:
- Nominal operating voltage: 12V
- Idle current: 6ma
- Low Voltage Warning current: 15ma
Theory:
U2 provides a 5V regulated voltage reference. U1 is wired as a comparator, it compares the fixed 5V regulated voltage to the voltage on the wiper of VR1, that is proportional to the 12V supply. When the supply drops below the set point, the output of U1 goes low, turning on Q1 and powering the beeper and the LED.
U2 provides a 5V regulated voltage reference. U1 is wired as a comparator, it compares the fixed 5V regulated voltage to the voltage on the wiper of VR1, that is proportional to the 12V supply. When the supply drops below the set point, the output of U1 goes low, turning on Q1 and powering the beeper and the LED.
The beeper consists of U4, a tone generator, and U3, a low duty cycle pulse generator. The tone can be changed by adjusting R7, the beep rate can be changed by adjusting R5. A small amount of hysteresis is provided by R1 and the current through LED1 and the beeper, this separates the on and off points for the circuit.
Battery Low Voltage Beeper Circuit
Simple Battery Low Voltage Beeper circuit board was made by printing the pattern (see below) onto
Press-n-peel blue circuit board transfer film with a laser printer. Etch
the board, drill the holes, and assemble the parts on the board as per
the board photo. Be sure to correctly orient the diode, electrolytic
capacitors, ICs, and transistor. The CA3160 op-amp may be difficult to
find, other low power CMOS op-amps may be substituted. A standard 741
op-amp would also work, but the idle current will be higher.
Alignment:
Connect the circuit to an adjustable DC voltage source. Set the voltage source to 11V or wherever you would like the circuit to turn on. Turn on switch S1. Adjust VR1 until the point where LED1 just comes on and the beeping starts.
Use:
Connect the circuit to the 12V source that you wish to monitor. There should be a fuse somewhere between the battery and this circuit. Turn S1 on, if the battery voltage is above the set point, nothing should happen.
As the battery voltage drops below the set point, the LED will light and a periodic beeping will come from the speaker. If the beeping becomes annoying, turn off S1. Be sure to charge the battery soon, excessive discharging will shorten the life of most rechargeable batteries.
Alignment:
Connect the circuit to an adjustable DC voltage source. Set the voltage source to 11V or wherever you would like the circuit to turn on. Turn on switch S1. Adjust VR1 until the point where LED1 just comes on and the beeping starts.
Use:
Connect the circuit to the 12V source that you wish to monitor. There should be a fuse somewhere between the battery and this circuit. Turn S1 on, if the battery voltage is above the set point, nothing should happen.
As the battery voltage drops below the set point, the LED will light and a periodic beeping will come from the speaker. If the beeping becomes annoying, turn off S1. Be sure to charge the battery soon, excessive discharging will shorten the life of most rechargeable batteries.
