An electronic switch that can be used to switch on both the
air-conditioner as well as fan of your room, one by one. The circuit
consists of power supply and control sections. The power supply section
is built around transformer X1, bridge rectifier BR1 and filter
capacitor C1. The 50Hz, 230V AC mains is stepped down by transformer X1
to deliver a secondary output of 9V, 300 mA. The transformer output is
rectified by the bridge rectifier and filtered by capacitor C1.
When the mains is switched on for the first time, pin 3 of IC CD4017
(IC1) goes high and relay RL1 energies to switch on the fan. When mains
is briefly switched off using S1 and then switched on, the power to IC1
is maintained by the charge on capacitor C1. At the same time, there is
a trigger pulse on the clock input (pin 14) of IC1, which advances the
decade counter and relay RL2 energies to switch-on the air-conditioner.
Both the air-conditioner and the fan will be turned off if the switch
is in the ‘off’ position.
Assemble the circuit on a general-purpose PCB and enclose in a suitable case. Fix the unit onto the switchboard. Use relays RL1 and RL2 with proper contact ratings. The current rating depends on the load that you are going to control.
Assemble the circuit on a general-purpose PCB and enclose in a suitable case. Fix the unit onto the switchboard. Use relays RL1 and RL2 with proper contact ratings. The current rating depends on the load that you are going to control.
