This two LED flasher circuit uses any DC supply from 3V to 12V. Flash rate is controlled
by R1,C1 and R2,C2. Larger values create slower fash rates, smaller values higher flash
rates.
Popular Posts
-
This is the schematic diagram of 3 channels audio splitter amplifier circuit which built using op-amp IC TL084. The 3 channels amplifier ... -
GDT’s are special type of gas filled tubes used for wide range of electronic/electrical circuits for providing protection against ligh... -
This is the 25W Class-A power audio amplifier circuit. The output devices are MJL4281A (NPN) and MJL4302A (PNP), and have high bandwidt... -
This is the tone booster schematic diagram which is published on Everyday Electronics, September 1978 edition. The peaks of frequencies i...