This two LED flasher circuit uses any DC supply from 3V to 12V. Flash rate is controlled
by R1,C1 and R2,C2. Larger values create slower fash rates, smaller values higher flash
rates.
Popular Posts
-
This is the schematic diagram of 3 channels audio splitter amplifier circuit which built using op-amp IC TL084. The 3 channels amplifier ... -
Simple Active Crossover Circuit Diagram with TL074 . An audio source, like a mixer, preamp, EQ, or a recorder, is fed to the input of the ... -
This circuit is a tester for flywheel based ignition systems in small aeroplane engines. Basically the same ignition coils are also se... -
The MAX1044 is a charge pump converter - it uses a capacitor as a "bucket" to pump charge from one place to another. In this cas...
