his circuit provides a simple means to determine the voltage of a low-impedance voltage source. It works as follows. P1, which is a 1-W potentiometer, forms a voltage divider in combination with R1. The voltage at their junction is buffered by T1, and then passed to reference diode D1 via R3. D1 limits the voltage following the resistor to 2.5 V. An indicator stage consisting of T2, R4 and LED D2 is connected in parallel with D1. As long as the voltage is not limited by D1, the LED will not be fully illuminated. This is the basic operating principle of this measurement circuit.
Find us on Facebook
Popular Posts
-
This is the schematic diagram of 3 channels audio splitter amplifier circuit which built using op-amp IC TL084. The 3 channels amplifier ...
-
This is the 25W Class-A power audio amplifier circuit. The output devices are MJL4281A (NPN) and MJL4302A (PNP), and have high bandwidt...
-
Build a 15W Bridge Audio Amplifier Circuit based TDA2002 . 15W bridge audio amplifier circuit which use 2 pieces of TDA2002. This is audi...
-
This is the simple 0-30V 20A High Power Supply with LM338 circuit Diagram. This is High current and Adjustable Volt 0 to 30V 20A. It easy ...
Powered by Blogger.